Rockbox.org home
Downloads
Release release
Dev builds dev builds
Extras extras
themes themes
Documentation
Manual manual
Wiki wiki
Device Status device status
Support
Forums forums
Mailing lists mailing lists
IRC IRC
Development
Bugs bugs
Patches patches
Dev Guide dev guide
Search



Donate

Rockbox Technical Forums


Login with username, password and session length
Home Help Search Staff List Login Register
News:

Thank You for your continued support and contributions!

+  Rockbox Technical Forums
|-+  Rockbox General
| |-+  Rockbox General Discussion
| | |-+  Rockbox not being detected in Mac after CF conversion
« previous next »
  • Print
Pages: [1]

Author Topic: Rockbox not being detected in Mac after CF conversion  (Read 921 times)

Offline sdesales

  • Member
  • *
  • Posts: 1
Rockbox not being detected in Mac after CF conversion
« on: December 18, 2015, 10:00:12 PM »
I have recently switched out from a 30GB iPod HDD to a compact flash card adapter to an SD card. I have noted that both Mac & PC do not detect my Rockboxed iPod as a hard drive. It knows that it's in there but it's not available for some reason. Before the conversion, I had my Rockboxed iPod and it worked just fine with both my Mac & PC. It even switches to USB keyboard when plugged in. Also, most of the time when I plug it in it displays one of three things... 1. The iPod "sad face" 2. Boots in to recovery mode and 3. It boots into the "Use iTunes to restore" page all of which can be navigated through by resetting the iPod. It seems that I was better off using my old HDD. Could anyone help?

Much appreciated,


Sean
Logged

Offline [Saint]

  • Rockbox Expert
  • Member
  • *
  • Posts: 1662
  • Hayden Pearce
    • Google+
Re: Rockbox not being detected in Mac after CF conversion
« Reply #1 on: December 19, 2015, 03:57:22 PM »
This absolutely smacks of filesystem corruption, failing to seat the adapter properly, or filesystem corruption caused by failing to seat the adapter properly.

You might need to ensure that it is correctly seated and functional before closing it back up, and then pack out the adapter plate so that it can't move around at all. Often these adapter plates are quite a bit thinner than the original disk, and in my experience often have very poor tolerances in their connections.


[Saint]
Logged
Using PMs to annoy devs about bugs/patches is not a good way to have the issue looked at.

  • Print
Pages: [1]
« previous next »
+  Rockbox Technical Forums
|-+  Rockbox General
| |-+  Rockbox General Discussion
| | |-+  Rockbox not being detected in Mac after CF conversion
 

  • SMF 2.0.17 | SMF © 2019, Simple Machines
  • Rockbox Privacy Policy
  • XHTML
  • RSS
  • WAP2

Page created in 0.066 seconds with 15 queries.