Support and General Use > Audio Playback, Database and Playlists
[Sansa Clip+] car radio connection
gomezz:
My only other idea is to try it with the 4GB card back in or even with no memory card?
blady74:
--- Quote from: gomezz on December 13, 2015, 08:11:21 AM ---My only other idea is to try it with the 4GB card back in or even with no memory card?
--- End quote ---
Sorry is my fault. I am not enough precise.
I connect Sansa without card.
I changed 4GB Sansa to 8GB Sansa.
Regards
gomezz:
Sorry, my misunderstanding.
Have you doubled checked each and every setting in the 8GB model to make sure it is the same as the 4GB model. I can't find any setting in my Rockboxed Clip+ relating to allowing to be read as USB memory by a car radio although there is reference to it in the standard firmware user guide.
gomezz:
Now found out how to change the USB setting:-
1) Boot up into Sansa standard firmware by holding the Left button while you power it on;
2) Go to Settings -> USB Mode which will allow you to change between Auto (detect), MTP and MSC;
3) Try changing USB Mode;
4) Power off on power on again into the Rockbox firmware and see if that makes a difference.
I note that there is another setting in Rockbox called Hide Internal Memory but as you are not using a memory card I don't think that is relevant.
I assume you use a USB connection to you car radio as you find it easier to browse and change music from the radio while you are driving rather than fiddle with the small screen on the Clip+ itself? I don't tend to change music on my Clip+ while actually on the move but will consider that for my next long trip.
gomezz:
Just tried it in my car and it works with all three USB Mode settings. Had to hide the internal memory though (I use that just for ad hoc recordings) for my radio (Pure Highway H260DBi) to see my music collection on a 32GB memory card.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version