iRiver H320 board damage - long screw in wrong hole :(

[7fathoms]

Greetings, I'm new here.

I swapped out the HDD and upgraded with a 32GB compact flash card, it worked all fine and dandy until I put it back together -  I stupidly put one of the two long screws into a hole meant for a short screw. The screw bit into the board and went across two of the circuit tracks, now the player is dead. It was absolutely gutting 

Does anyone have any experience of this, or if it is repairable, or does anyone have a board they want to part with?

[saratoga]

Clean it out and see if you can prevent the hole from shorting out the circuit board.

[7fathoms]

Thanks for the reply.

I'm unsure whether I have shorted out the tracks or broken a track - does anyone have a photo of this part of an undamaged board?

Also does a short on the board usually result in a fried component somewhere?

[saratoga]

I'm unsure whether I have shorted out the tracks or broken a track - does anyone have a photo of this part of an undamaged board?

Since those are through-holes, theres probably not much there to be damaged.  I would try and see if I could unshort it, and if that fails, buy a new player.

[[Saint]]

I'm unsure whether I have shorted out the tracks or broken a track - does anyone have a photo of this part of an undamaged board?

Why yes, yes we do.
We have high resolution* scans available on our wiki, in the IriverInfo page:
Front
and,
Back

Also does a short on the board usually result in a fried component somewhere?

It is largely impossible to give a definitive yes or no answer here, as there are a lot of variables to consider.
Unfortunately the best I can offer is "possibly".


[Saint]

(*These image files are approximately 3000x5000px resolution and as such weigh in at approximately 25MB each. Because of this, you might need to give your browser some time to render the images.)

[7fathoms]

That's awesome, thank you. It doesn't appear that the screw damage actually affects anything other than the through holes, so I'm wondering if I've done something else while putting it back together.

I'll have another go.

Thanks again.

Dan