Support and General Use > Hardware

Problems pressing "Up" button

<< < (3/3)

benosoft:
Well, even with trying very hard I couldn't get any reading more than 1 or 2
steps from their 'natural' (click) value.
I think the 'Left' range could be changed to 0x42-0x46 without getting any artifacts.
I'll try to test extensively under these conditions...

Mr. Brownstone:
I tried that debug-mode option. I get the following results for ADC_BUTTONS:

Normal: FF
Up: 20 hard-push, up to 25
Down: 65
Left: Flickers between 42 and 43
Right: 86 hard-push, up to 8F

gearheadE34:
I have had problems with the double-button-press and the up key, and it is only in the rockbox FW. I am getting similar readings to those of Mr. Brownstone, so it doesnt make sense that I would have a problem, especially considering that the up buttonpress is often accompanied by a RIGHT buttonpress, the opposite of what you guys are getting. I may be having a problem all my own, but i thought I'd throw it out there.

this problem first arose for me with early rockbox FW, and then it dissapeared, and now it has come back again, if that makes any difference

Navigation

[0] Message Index

[*] Previous page