Installation / Removal > Rockbox Utility

Having a problem with installer on Sansa Clip+

(1/1)

JtheJJJ:
Hello. I can't seem to get the Rockbox firmware installed on my new Clip+. I'm experienced with installing firmware on devices, and I think I'm doing everything correctly. The utility goes through all of its steps, and appears to have worked correctly. I eject the device...and then.....the firmware doesn't actually install on the device. I don't get the "upgrading firmware" message on the device, and it doesn't turn itself off. The same Sansa firmware (V01.02.16A) is still there - even though the installer worked, gave no error messages, etc.

I've tried several times, always with the same result. Any ideas on how to troubleshoot this?

saratoga:
Double check that you installed to the right drive letter.

JtheJJJ:
Yippee! Thank you very much, that was indeed the problem. It was installing to the wrong drive letter. Everything works now.

Navigation

[0] Message Index