Support and General Use > Hardware

Sansa fuse Plus battery calibration

<< < (4/5) > >>

saratoga:
Take the voltage data you posted above and place it into that array.  From what you said above, I think you already did this?

fennectech:
the problem is there is ALOT more data than is available in my array   also the charge curve and disscharge curve are different

saratoga:
Let me be very slightly more specific: take the data you posted above (not the mostly empty results you just posted), select the values that correspond to entries in those arrays as described in the comments above each array, and then paste them into the file.

I think this should have been obvious though? 

fennectech:
[fennectech@archos build]$ git commit
On branch master
Your branch is up-to-date with 'origin/master'.
Changes not staged for commit:
   modified:   ../firmware/target/arm/imx233/sansa-fuzeplus/powermgmt-fuzeplus.c

when i try to do a commit  it does that

saratoga:
I'm not too familiar with git, but have you tried doing 'git add ../firmware/target/arm/imx233/sansa-fuzeplus/powermgmt-fuzeplus.c'?  I think that message just means that you have modified a file but not added it to your commit. 

Navigation

[0] Message Index

[#] Next page

[*] Previous page