Support and General Use > Hardware

Sansa Clip+ screen crashes after "Scanning Disk.."

(1/1)

Faithorscience:
I installed Rockbox through Rockbox Utility, everything went fine, until I turn on the player to start Rockbox. It stays on "Scanning Disk.." for about a minute and then a really ugly screen appears, like it broke. In some other cases, it stays on "Scanning Disk.." and then it just turns off and I can't turn it on for a while (not even in the standard firmware). Help would be much appreciated!  ;D

Edit: Now after the loading screen it says: "Data abort at 30E55508(...) FSR 0x8 ( domain 0, fault 8 ) address 0x6014DE90"

magick:
Hi, I have the same problem with my Sansa Fuse.

Did you find a solution to this?

Navigation

[0] Message Index