Rockbox Development > New Ports
Creative ZEN X-Fi
robertdundee:
Thanks, after the device loads it goes to the recovery mode. After that shall I disconnect and reboot?
pamaury:
Ok, let me ask clearer question:
* does the device boot without plugging usb ? If not, use sbloader to get the recovery menu and wait until battery is charged
* does the device boot straight to recovery menu (as opposed to boots the OF or Rockbox) ? If not, you need to send a new firmware to the device, use sendfirm to do that
robertdundee:
The device boots straight to recovery menu after sbloader is executed. The device does not boot without usb plugged
In the pc it says that the storage media is 60 mb. When I try the sendfrm the output is "Error occured during sending". Iam going to use the sbloader again and leave it charging for a while. Thanks again!
Device is fully charged. I ran the sbloader booted into recovery mode. Then disconnected from the usb and selected reboot. The screen went white. Repeated the whole procedure of rebooting from the recovery menu and the screen went yellow. After repeating again and selecting reboot the screen went red. It is impossible to access recovery menu using the play on buttons
robertdundee:
I have tried everything. At reboot of Recovery Mode the screen changes color and then the unit shuts down
pamaury:
That sounds very strange, could you come on IRC (http://www.rockbox.org/irc/), that would greatly speed up the discussion. My pseudo is pamaury, I'm usually online the whole day (french time).
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version