Sansa Clip v2 not enough memory installation failed --> dead

[Sanjix]

Hello everyone,

I just wanted to install the Rockbox Software on my Sansa Clip V2 but I forgot to delete some Songs to make some free memory space.
The Auto-Installer stopped..
First, when I turned it on, I saw the Rockbox sign, then the Display shows, I should connect it with an USB Cable - so I have done it.
But then the Sansa turned off and now I can't turn it on anymore.

Can you help me please?

Greetings

[saratoga]

You installed the bootloader but not the main build. 

Reboot into the sandisk firmware and finish the installation.

By the way, rebooting a player midway through flashing a firmware is in general a really terrible idea.  Fortunately the Clips are hard to brick while flashing. 

[gloco]

I had my clip act up, all I did was hold down the power button for 20 seconds and it came back on:

http://kb.sandisk.com/app/answers/detail/a_id/1121/~/sansa-player-is-not-turning-on

[Sanjix]

Hi,

thanks for your Post.

Fortunately I could turn on the Sansa today morning and I repeat the installation, now it is flashed successfully.
Impressive, how good this Software with its many features is!

[mohsinj677]

  This post is so great and nice   

 First, when I turned it on, I saw the Rockbox sign, then the Display shows, I should connect it with an USB Cable - so I have done it.
But then the Sansa turned off and now I can't turn it on anymore.

[saratoga]

Like gloco said, try holding power until it reboots.