Support and General Use > Hardware

Sansa fuze v2 lineout with RB3.13

(1/1)

Njones:
Will the use of the im413 dock through the dock connector work on the fuze v2 in the 3.13 release?

saratoga:
No, but if you want to follow the line out status you can look here:

http://www.rockbox.org/tracker/task/12074

Njones:
How do you add the patch to the fuze? I'm not very computer literate, so simple directions please.

[Saint]:
You would need to check out the Rockbox source, set up a development environment, compile the toolchain, patch the source, and then compile your binary. All of this is described in detail in our fine wiki.

...if you're not very computer literate, you might just want to wait and hope it gets added to the official repository and ends up in the development builds at some stage though.


[Saint]

Njones:
Thanks. I think I'll wait for it to get added in the development builds since everything you wrote was "Greek" to me.

Navigation

[0] Message Index