Rockbox General > Rockbox General Discussion
How can I automatically boot Original Sansa firmware instead of Rockbox?
Crafty:
--- Quote ---They probably flash the NAND chips before they solder them onto the board.
--- End quote ---
maybe they may use the mem card pinouts. <shrug>
saratoga:
--- Quote from: Crafty on February 23, 2013, 07:01:41 PM ---
--- Quote ---They probably flash the NAND chips before they solder them onto the board.
--- End quote ---
maybe they may use the mem card pinouts. <shrug>
--- End quote ---
What do you mean?
Crafty:
I don't know the architect and I'm old 68hcXXX schooled.
I mean they might ground one pin and flash it with the MicroSDHC pins.
I would think there is some hard code somewhere.
saratoga:
--- Quote from: Crafty on February 23, 2013, 09:42:42 PM --- I don't know the architect and I'm old 68hcXXX schooled.
I mean they might ground one pin and flash it with the MicroSDHC pins.
I would think there is some hard code somewhere.
--- End quote ---
Ah no, with a blank NAND the device is essentially dead since USB, SD, etc are all software controlled.
Crafty:
back to OT,
could it boot in RB and have RB goto the address of the OF? Use the right button to run RB.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version