sansa clip plus install problem

[iridium]

the .bin property for DID says 4.00 KB (4,096 bytes) "size on disk" with a "size" of 114 bytes

I am not sure how to tell if my Plus "rebooted" automatically ...
how can I tell?

How exactly do I reboot manually?
Should l try reboot manually?

[saratoga]

the .bin property for DID says 4.00 KB (4,096 bytes) "size on disk" with a "size" of 114 bytes

I don't care about that, its not the firmware file, so you don't need it.

I am not sure how to tell if my Plus "rebooted" automatically ...
how can I tell?

It will turn off and then on. 

[iridium]

thank you for your help so far ... so how do I get Rockbox on my Clip+
the utility list seemed to show everything went well ... ?
still no Rockbox on my Clip+
need help

[saratoga]

Like I said before, I would try again, and make sure the clipp.bin file is written to the player, then disconnect, and make sure its gone when it reboots. 

[iridium]

clipp.bin file written to player, disconnected, it is no longer listed on F drive
i do see a DevIcon .fil file and then the folders for Music, etc.
Still no Rockbox on my Clip +
still need help

[iridium]

thank everyone for their help ...
still unable to install Rockbox ...
I have followed everything I that has been recommended

your help appreciated
i would like to be able to use Rockbox

[iridium]

I was finally able to install Rockbox ... the problem was I had not selected the proper drive (F) in the File/Configure/Select Device menu of Rockbox utility ... once I selected F drive, Rockbox loaded up on device reboot.

Thanx to everyone for their help.

[doowkram]

This Helped me so much!  Thank you!

Mark