Rockbox won't work on Sansa Clip+

[kakkerpolakker]

Hello everyone,

Before I begin: I'm totally novice with Rockbox and my Sansa Clip+.

So about a week ago I bough my Sansa Clip+, installed Rockbox following all instructions, and it worked for a couple days, and my life was sweet. Here's what's happened then:
— I left my Sansa recording some programme from the radio.
— After I came back, the following message showed on the screen:
"Divide by zero at 300
pc: 3007322C sp:300AFD
bt end"

— Now, every time I try to turn on the Sansa, it first shows the rockbox logo with "Boot 4.0" on the top.
— After a split second it changes to another screen with the rockbox logo, and "ver. 3.12" on the top
— The mp3 works for about 4-5 seconds, I can browse the menu, try to play music...
— And then this screen appears:
"Divide by zero at 300
pc: 3007322C sp:300AFD
bt end"

The Sansa firmware loads perfectly, but come on, the Sansa firmware sucks compared to Rockbox, so...

Help!


 

[saratoga]

Maybe the install got corrupted?  Try checking the disk for errors and then reinstalling a new build. 

[kakkerpolakker]

Well, I did that — the disk is fine (no errors detected).

I tried installed Rockbox twice again — same problems occur.

 

[whiskers75]

Your Sansa may be defective. My clip+ works like a dream, same version and all.