Rockbox General > Rockbox General Discussion
USB still not working on sansa clip+ after installing 3.11
saratoga:
--- Quote from: cs96and on April 19, 2012, 08:34:29 AM ---I cleared my cache and reinstalled the bootloader, but it still boots into the Sansa firmware when plugged in when turned off.
--- End quote ---
That means you used an older version of rbutil. If you patch with the current one you get rockbox by default.
cs96and:
I am using Rock Box utility 1.2.13. I just re-downloaded it and tried again but still have the same problem. It always boots into the sansa firmware when plugged in from off.
Post Merge: April 24, 2012, 11:41:03 AMAha! I didn't realize that you had to boot into the sansa firmware first for the boot loader to be upgraded. I booted into the sansa firmware (without USB cable attached) and I got a "Firware update in progress" notice. Now when I plug in from off, I get the RockBox firmware.
However, RockBox USB mode has stopped working again. Neither the player or SD card is accessible.
JayNYC:
i am basically having the same problem. i bought a brand new Sansa Clip+ yesterday, installed the latest greatest version of Rockbox, and when I connect it to my Win7 64 Bit desktop, it doesn't work right. It does not mount properly, it does not even eject properly, explorer hangs, etc.. Basically every symptom that has been described in this thread I have experienced.
cs96and:
It seems to me that there is a serious problem here that is affecting many people. USB just seems to be very flaky on the latest firmware, sometimes it works, sometimes it doesn't. Is anyone actually looking in to this issue?
I think it all stems from the failure to install the drivers correctly in Windows when it is plugged in for the first time.
In the end, I managed to get mine working by plugging it in to a different USB port on the computer than I used initially. That seems to trick Windows in some way.
For anyone who is still having problems even after trying a different USB port, try holding down the home button when you plug it in. That will boot you into the original firmware so you can transfer files.
markemark:
Updating to a build with FS #12639 fixed the USB problems I was having with my Clip Zip. Perhaps try a current build?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version