Support and General Use > Hardware

Clip+ "USB device not recognized"

<< < (2/3) > >>

Isaansound:

--- Quote from: saratoga on March 25, 2012, 06:04:21 PM ---http://www.rockbox.org/wiki/SansaAMS#AMSv2_issues_40Fuzev2_44_Clipv2_44_Clip_43_44_ClipZip_41

--- End quote ---
"USB was enabled after the release of 3.10. Users should either reboot into the Sandisk firmware for USB transfers (see manual section 3.1.3), or upgrade to the current build to enable rockbox USB mode. "  I have 3.1and it doesn't recognize my device "unknown device"

yapper:
USB is NOT enabled in 3.10. You need a more recent build.

bluebrother:

--- Quote from: Isaansound on March 31, 2012, 12:35:11 AM ---I have 3.1and it doesn't recognize my device "unknown device"

--- End quote ---

Rockbox 3.1 did not support the Clip+ at all.

Haydn:
I also installed Rockbox 3.10 on my Sansa Clipp.  Now when I plug it into my usb it doesn't show up at all. So i basically have an mp3 player  where I can't put music on it....   Is there any solution to this?

tpijag:
You could read this very thread you posted to and install a version that includes USB support. The current release is 3.11.2. so I am not sure why you are installing an old version. 

This issue has been discussed many times and answers are throughout the forum, the manual for your unit and the status notes for your unit.

Even if you have a reason to stay with your current install - which clearly states that USB support is NOT included, you have functioning player. Simply boot into the Sansa firmware for usb support and load music. It is all described very clearly in the manual for your version and throughout on Clip+ specific thread.

Navigation

[0] Message Index

[#] Next page

[*] Previous page