Support and General Use > Hardware

RB new install on Fuze V2-lost my music and device is full, usb "unknown"

<< < (3/4) > >>

tpijag:
I am very confused. Could you clarify. For what I have read:

1. You are using 3.10 which is the current release, correct? The current build changes multiple times a day so it is newer than the release.

2. You are not using the current build if you are using 3.10 release. correct?

3. You have read and previously quoted that USB support is not in 3.10 release, but is in more recent builds. Why would you expect USB to work in 3.10?

FYI, current build now is 3.11 so maybe all this is mute and we can all move on to something productive.

Isaansound:
It amazes me that after several days of messaging all I get is discussions over semantics rather than the help I need. I say again...
1. At the time (March 23)  when I installed RB 3.10 was the current version.
2. I do have and still have 3.10
3. The documentation at the time of this install clearly said that this version of RB supports USB and that OLDER versions do not.
4. Therefore my USB  should work.
5. It doesn't.
6. ALL I need to accomplish is to get my USB working. Any help towards accomplishing that goal would be truly appreciated.

yapper:

--- Quote from: Isaansound on April 01, 2012, 12:59:08 PM ---6. ALL I need to accomplish is to get my USB working. Any help towards accomplishing that goal would be truly appreciated.

--- End quote ---

Install 3.11

evilnick:
1. No it wasn't. At that time 3.10 was the most recent release but nowhere near the most recent build.
2.
3. No it didn't. You read the manual for the most recent build and thought it applied to 3.10. It doesn't.
4.
5.
6. Install 3.11.

There is some discussion about changing some of the technical words used here so that they are easier (for the user and not the developer) to understand.

saratoga:

--- Quote from: Isaansound on April 01, 2012, 12:59:08 PM ---It amazes me that after several days of messaging all I get is discussions over semantics rather than the help I need.

--- End quote ---

It would help if you'd read the replies to your posts a little more carefully.  It was explained quite clearly to you when you asked before:

http://forums.rockbox.org/index.php/topic,33845.msg196307.html#msg196307

If you found that confusing, I think its really your own fault.


--- Quote from: Isaansound on April 01, 2012, 12:59:08 PM ---3. The documentation at the time of this install clearly said that this version of RB supports USB and that OLDER versions do not.

--- End quote ---


--- Quote from: Isaansound on March 31, 2012, 12:35:11 AM ---"USB was enabled after the release of 3.10. Users should either reboot into the Sandisk firmware for USB transfers (see manual section 3.1.3), or upgrade to the current build to enable rockbox USB mode. " 

--- End quote ---

I think the problem here is that you're ignoring the word "after" since you seem to have interpreted it as meaning "before".  This is not correct.  We really do mean "after".  3.10 was released in November, then 2 months later USB support was finished.  So if you're running an old build (like 3.10) you need to update to one from late December or newer if you want USB.  Thats why the warning says that 3.10 doesn't have USB, but that the current build does.  Make sense?

Navigation

[0] Message Index

[#] Next page

[*] Previous page