Rockbox Development > New Ports

Creative Zen Vision:M

<< < (87/136) > >>

Falafel:
 :o Forgot to add 'Hjukebox2.jrm'.

It Works!!

The prog only use the upper left corner of my screen but still! :D

LambdaCalculus:
Falafel, can you snap a picture and show us what it does?

Falafel:
Sure,

Bureaublad.rar

I think its because ZV uses a different memory address to map the lcd to.. But I haven't checked yet.

Edit:
Where do you set LCD_HEIGHT and _WIDTH?

mcuelenaere:

--- Quote from: Falafel on February 20, 2008, 09:51:12 AM ---Edit:
Where do you set LCD_HEIGHT and _WIDTH?

--- End quote ---
firmware/export/config-creativezvm.h

edit:
after seeing the photos, I would say also check lcd_init_device() in firmware/target/tms320dm320/creative-zvm/lcd_creativezvm.h;

more specific IO_OSD_OSDWIN0OFST (the format is (LCD_WIDTH*bpp)/256 )

Falafel:

--- Quote from: mcuelenaere on February 20, 2008, 10:03:46 AM ---more specific IO_OSD_OSDWIN0OFST (the format is (LCD_WIDTH*bpp)/256 )

--- End quote ---

Hmm, but what exactly is it that this does?
I mean, I've changed it a bit and my screen gets garbled.. And if I set Height and width to 480x640 (because of the portrait-mode) it fills the screen almost, but it still misses a piece on the right side if I hold in the ZVM way. (too bad I have to go, because now I don't have time to take pictures)

Navigation

[0] Message Index

[#] Next page

[*] Previous page