Rockbox Development > New Ports
Creative Zen Vision:M
bgdwie:
I think that is in relation to the ability to transfer PFS music to and from the player, not the firmware. Also, from what i have read, you won't be able to get any information from creative or TI without signing an NDA, so there is no way they'd let you put the info in an open source firmware solution...
aaronwi:
--- Quote from: Falafel on July 17, 2007, 12:44:39 PM ---Here ya go: http://www.mediafire.com/?93sxbsdgm1r link to first 20MB
And just for good measures: http://www.mediafire.com/?cv2zd0hcb9n link to First 80mb
--- End quote ---
What is that from? Zen Vision, M, or W?
What program did you use to make the image?
And what firmware version do you have on your player?
looks like system file references don't begin untill 0x00144200
I think anything useful wont be past 0x001882C8, where a song index starts
otherwise, I don't see any matches to the latest ZVM nk.bin file, even simple things like languages and menu words, no matches.
Someone should take a drive from another zen with different firmware version, and see if it works, and if so which version gets used.
Falafel:
its from a vision (non m or w) firmware version: "ZENVision_PCFW_L16_1_42_01e"
I kopieed directly from the drive using 010 editor.
I'm going to clean out the drive completely and try to install firmware on it..
after that I will knoow for sure that all the bytes in the drive are in fact firmware. after that'll change some and then we will know if the software is checked after installation.
Transience:
Assuming the vision W and M are the same in terms of firmware upgrades, it seems that any checksumming done by the player is done using code stored on the player's ROM, as the HDD can be changed out on the vision W without any problems. http://onemansblog.com/2007/07/20/tutorial-how-to-upgrade-the-creative-zen-vision-w-hard-drive/
saratoga:
--- Quote from: Transience on July 23, 2007, 01:05:15 AM ---Assuming the vision W and M are the same in terms of firmware upgrades, it seems that any checksumming done by the player is done using code stored on the player's ROM, as the HDD can be changed out on the vision W without any problems. http://onemansblog.com/2007/07/20/tutorial-how-to-upgrade-the-creative-zen-vision-w-hard-drive/
--- End quote ---
While I agree that the checksum must be calculated by the firmware in ROM (since doing it from the disk would make absolutely no sense at all), theres nothing specifically in that link to suggest its the case.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version