Rockbox General > Rockbox General Discussion

Computer not recognizing Sansa Clip+ after installing Rockbox

<< < (2/2)

redcap:
thank you tpijag, yes it helps, sorry I hadnt read all the documentation, it explains there how to boot with original firmware, although there its not clear that to have usb connectivity we should boot the original firmware.

The solution is on the link, press LEFT while powering Clip+, and connectivity works.

redcap:
By the way, still about this subject, I now realize (newbie that recently bought a rockboxable device, yupiiiiii) that the documented behavior is to boot into the default firmware if turned off and connected to usb port. This doesnt happen with the current rockbox firmware I installed: 3.10, with the latest firmware 1.02.16F.
its no real problem, only for people not informed, so I think I its a good idea for me to change the manual so it points out this issue.

I would like to THANK all the contributors of this wonderful project. have an amazing year!

saratoga:

--- Quote from: redcap on February 27, 2012, 11:23:05 AM --- that the documented behavior is to boot into the default firmware if turned off and connected to usb port. This doesnt happen with the current rockbox firmware I installed: 3.10, with the latest firmware 1.02.16F.

--- End quote ---

We disabled this recently since we now have USB support in rockbox.  Unfortunately it didn't occur to anyone that this would cause problems for people who kept using older builds like 3.10 that don't have USB. 

Navigation

[0] Message Index

[*] Previous page