Installation / Removal > Rockbox Utility

Install of new release

<< < (2/2)

saratoga:
Yes that will work.  However I would not install 3.9.1 at this point.  Its quite old. 

Bruiser13:
Saratoga - I solved the problem. Of course, something obvious..  The fuzepa firmware file I was pointing to was on the desktop. I successfully installed 3.9.1.  It was released Sep 2011 so it can't be too outdated I wouldn't think, at least for my purposes. Thanks so much for all you help!!

saratoga:

--- Quote from: Bruiser13 on November 30, 2011, 12:00:04 PM --- The fuzepa firmware file I was pointing to was on the desktop.

--- End quote ---

Updating rockbox doesn't involve a fuzepa firmware file, thats only used the first time you install.  I think my original reply was on target.  It sounds like you told the installer to install the rockbox build to some other device or disk drive other then your Sansa. 


--- Quote from: Bruiser13 on November 30, 2011, 12:00:04 PM --- It was released Sep 2011 so it can't be too outdated I wouldn't think, at least for my purposes. Thanks so much for all you help!!

--- End quote ---

It was branched from SVN on 2011-06-27.  I would probably not downgrade 5 months worth unless there was a good reason.  What is your reason for wanting to run an older build anyway?

Bruiser13:
The whole issue to change versions was due to installing a new 32GB Micro card, rather than use a 16GB card. For some reason, version 3.7.1 won't recognize the 32GB card. The installed version 3.9.1 seems to work fine, so I'm happy with it as of now.

As far as the install, for some reason, the file fuzepa needed to be located in the root directory of my fuze in order for the update to be downloaded to the proper location. I'm not sure why, however.

Thanks much for all your help!

Navigation

[0] Message Index

[*] Previous page