Third Party > Repairing and Upgrading Rockbox Capable Players
Iriver H320 CFMod ATA error: -80
Julian67:
I just had the same error with a Transcend 133x 8GB card. I tried a very old Kingston Elite Pro 50x 2GB card and that booted fine, all with current bootloader and release 3.10. The Transcend card also causes problems with two different cameras and several card readers; it's a brand I will avoid in future.
btw this was on H340.
jmech:
Hi,
same here with a H320 + Transcend 133x 64GB...don't have a different card at hand but will post if it can be fixed by simply replacing it with a different one.
-JM
gap736uk:
I have a Transcend 32Gb, 400x card and initially I had the -80 error. I then replaced the bootloader with one that I came across that is patched and set to give debug info.. and got the -81 error on that occasion (whether or not I had it formatted as FAT as opposed to FAT32 on the first attempt i'm not too sure... I *think* that that may have been another issue but I've not tested this to verify)
Elsewhere I've read that the issue might be that the bootloader needs some of its ATA settings changed to remove some of the options that are no needed which could be leading to the issue.. but I've not got experience with this. (there is a technical document available on the web that describes the ATA/IDE side of this CF card, but too technical for me to link this up with how to adapt the bootloader to cope with this card (if if can be done!!) ) .
I have been in touch with someone via Ebay who has done the CF mod on H3**s with the Kingston 32Gb 133x cards sucessfully... however, you can no longer get these!!! and i've not heard good things about the 266 speed version that is now out.
Anyone recommend any higher capacity CF cards that DO work with the H3** CF mod?
thanks.
poulpe63:
OK, I'd got the same problem...
I bought the IDE-CF adapter, a Transcend 32GB 133x and the current firmware 1.29K with the "official" rockbox bootloader.
After several attempts, what I did ?
1) I plugged the original Had disk in the H320.
2) download the already patched 1.31K firmware there : http://hendrik.feuerware.com/rockbox.htm
3) I followed the procedure for upgrading with the h300.hex file (from there : http://iriver.wikia.com/wiki/H3xx_Firmware_Instructions)
4) Then, I removed the Hard Disk, and put the CF+adapter.
5) And, finally, the H320 was started : no more error :), and the boot time is very short :)
Currently, I'm putting all my files in the CF and the H320 is charging.
If I notice something that's not working, I will update that post. (but everything seem fine so far).
Navigation
[0] Message Index
[*] Previous page
Go to full version