Rockbox Development > New Ports
Sansa Clip Zip
dotrockbox:
--- Quote from: Gurglin on December 20, 2011, 11:06:12 AM ---...
--- End quote ---
Hi Gurglin,
The USB is definitely a work in progress, but you can still use the USB connection while booted in the Sansa firmware. The bootloader you mentioned is the same one that I use, and it just requires you to press the down volume as you turn it on to boot into the Sansa side.
As for RDS, it has been working for me and I didn't experience the issue you talked about, probably because I use a different theme. Try changing your theme to one of these: http://themes.rockbox.org/index.php?target=sansaclipzip I'm currently using lebellium Samsung-like, so I know that has RDS support.
As for your system freezes, I must say that I haven't experienced anything like that except when I was connected through USB. Even then it wasn't a true freeze since after disconnecting the USB, waiting for a bit since it doesn't automatically disconnect, and then pressing the power, everything was good. If this is the type of freeze you mean then that's the reason. Just use the USB from the Sansa side for now. Other than that, it's been super stable.
dfkt:
--- Quote from: Gurglin on December 20, 2011, 11:06:12 AM ---I have installed latest version r31359 with the bootloader (sadly enough, not a dual boot, as far as I see) by DFKT. Am amazed but also confused by the huge amount of options.
--- End quote ---
The bootloader is dual boot. You have to hold the left or vol- button for the OF to boot. I just uploaded an official v4.0 bootloader there, you might want to upgrade if you didn't already.
--- Quote from: Gurglin on December 20, 2011, 11:06:12 AM ---I have a strong impression the RDS system works, even if only partially, but the line where it is shown is below the visible area of the screen. I actually can see the top of some letters. Would it be possible to resize the screen? Or to delete the useless separation line that prevent seeing the RDS line?
--- End quote ---
Are you using my theme? If so, RDS works fine in the .fms - try to reload the theme. (I assume you are using at least some 3rd-party theme, otherwise you wouldn't have an .fms to delete lines from.)
In any case, you might want to run checkdisk on the Zip and SD card - maybe your memory is corrupted.
dotrockbox:
--- Quote from: dfkt on December 20, 2011, 04:07:17 PM --- I just uploaded an official v4.0 bootloader there, you might want to upgrade if you didn't already.
--- End quote ---
Thanks for the new bootloader, dfkt. I'll have to try your theme sometime now that you updated it to support RDS.
I'd probably use your custom build with the extra patches as well, but the last item "channel swap" makes it seem as though the left and right channels would be swapped. Not sure why I'd need/want that, so I used your list of patches and compiled my own a few days ago.
Gurglin:
dotrockbox, dfkt, thanks for your answers and advices. You are right. Everything works fine now.
dfkt:
--- Quote from: dotrockbox on December 20, 2011, 07:28:48 PM ---I'd probably use your custom build with the extra patches as well, but the last item "channel swap" makes it seem as though the left and right channels would be swapped. Not sure why I'd need/want that, so I used your list of patches and compiled my own a few days ago.
--- End quote ---
Channel swap is of course optional, not mandatory. It's enabled/disabled in sound settings > channel modes.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version