Thank You for your continued support and contributions!
On a side note, are the mappings of SV1 the same for LCD and non-LCD remotes?
Now I've eliminated SV1 as being part of the remote (!) and as the circuit only addresses some of the wires for an LCD remote (obviously we do not need any of the LCD-related lines), will I be okay connecting my plug to the circuit only, or do you think it is it safer to keep the other wires connected to an LCD remote for completeness?
The receiver was easy to track down, but resistors seem to be a can of worms - I can filter by resistance but still getting hundreds of results on the component vendor site. Is there a specific type I should be looking for (apart from the actual resistance value)? There also appear to be the classic resistor types and ones that look more like chips. Do the other, non-ohm properties of the resistor make much difference?
Page created in 0.163 seconds with 21 queries.