Installation / Removal > Rockbox Utility

Rockbox load on iRiver H140 (6.6E)

(1/1)

iVinyl:
Hi folks.  For some reason I cannot get this to take. The bootloader and install complete but the machine still boots up as an iRiver. Any ideas?  native FW is 6.6Eu

regards Chris

bluebrother:
Have you actually performed the firmware upgrade procedure?

iVinyl:
Thanks for responding quickly. I upgraded the iHiver's own firmware to 1.66 (it was 1.63) and then used the Rockbox utility to do a full install.  I have removed the installation and repeated a few times, in both PC and Mac environments. Everything seems to work but the device still boots as an iRiver.

I supplied the firmware (1.66 and 1.65E)  from iRiver's site and from the Rockbox mirror site

Going back to version 1.65E - made no difference.

Do I need to go back to an earlier version of the firmware? I'm assuming that the Rockbox utility does the necessary modification to the original firmware file. I think I see something of that effect as it scrolls through the actions.
Post Merge: April 21, 2011, 09:37:07 AMI sussed it -  the firmware does not load if there is already a hex file already on the drive, and the upgrade only works if you are upping the version number.

The solution was to upgrade iRiver to 1.65, remove the 1.65 v hex file, then use the 1.66 hex file through the installer and lastly - since familiarity breeds contempt - remember to do the firmware upgrade at the end.

many thanks

Chris

Navigation

[0] Message Index