Support and General Use > Hardware

Sansa Fuze v1 SDHC problem...

<< < (2/2)

saratoga:

--- Quote from: silverwolf7 on April 17, 2011, 03:52:22 PM ---I tried the patches, I get the same error message with both-

amsv1_sd_normal_speed.patch:

"Hunk #1 FAILED at 338. 1 out of 1 hunk FAILED -- saving rejects to file firmware/target/arm/as3525/sd-as3525.c.rej"

amsv1_cmd6_delay.patch gives the same message, except the failure is at line 349.

--- End quote ---

The patch applies fine, so its probably something wrong with your check out.  Have you applied other patches?

Regardless, since both those patches change just one line each its probably not going to kill you to copy and paste the change manually ;)

silverwolf7:
Hmm... I had a fresh checkout, I just used the default svn ( svn co svn://svn.rockbox.org/rockbox/trunk rockbox). Strange that it wouldn't work. I don't mind patching it manually though- forgot about that earlier. There's no chance of a one-line manual patch messing up the firmware is there?
Post Merge: April 18, 2011, 01:13:41 PMFinally finished compiling (cygwin took hours to do the arm-elf-eabi-gcc update, etc). It works! Thanks Bertrik.

This should be included in the next build, since it only changes one line there isn't much chance of a serious bug coming from it. I used the "amsv1_cmd6_delay.patch" for reference.

AlexP:

--- Quote from: silverwolf7 on April 17, 2011, 07:35:34 PM ---This should be included in the next build, since it only changes one line there isn't much chance of a serious bug coming from it. I used the "amsv1_cmd6_delay.patch" for reference.

--- End quote ---

The length of the patch is completely irrelevant.

Navigation

[0] Message Index

[*] Previous page