Rockbox General > Rockbox General Discussion
error running rockbox in linux SDL
powerpan:
ver 3.8
configure select SDL, Normal
run ./rockbox
select a mp3 file, then :
SDL_WaitEvent() error
.....
SDL_WaitEvent() error
SDL_WaitEvent() error
SDL_WaitEvent() error
Segmentation fault
what's wrong with the build?
Ver 3.8.1
when playing a MP3,
Segmentation fault
then quit.
after remake,
SDL_WaitEvent() error
SDL_WaitEvent() error
SDL_WaitEvent() error
SDL_WaitEvent() error
SDL_WaitEvent() error
X Error of failed request: BadWindow (invalid Window parameter)
Major opcode of failed request: 4 (X_DestroyWindow)
Resource id in failed request: 0x420000d
Serial number of failed request: 116
Current serial number in output stream: 114
while compiling sim any model mode, error is the same. don't know what's wrong.
and the same error while making any target choosing Simulate build, please figure out how I made wrong, thanks .
found problems, error opening codecs.
gevaerts:
--- Quote from: powerpan on April 13, 2011, 12:20:37 AM ---found problems, error opening codecs.
--- End quote ---
Did you run make install after recompiling?
powerpan:
sure, did as the docs told to do.
when remove the codec dir, it will report codec could not be loaded error, will not quit with the errors I posted, but when it could find the codec, error came.
saratoga:
--- Quote from: powerpan on April 13, 2011, 08:00:51 PM ---sure, did as the docs told to do.
when remove the codec dir, it will report codec could not be loaded error, will not quit with the errors I posted, but when it could find the codec, error came.
--- End quote ---
Do a clean build and install, post the log and the exact error message you got.
powerpan:
problem clear after install bin2utils by rockboxdev.sh
I have cross compiler arm-none-linux-gnueabi-gcc so I saw the tool is going to install the tool chain, then I terminated it. so the problem comes.
can I use arm-none-linux-gnueabi-gcc as the compiler?
thanks
Navigation
[0] Message Index
[#] Next page
Go to full version