Support and General Use > Hardware

Sansa Clip Plus Refreshing your media

<< < (2/3) > >>

Roseweave:
Having the same problem. There must be a more convenient solution?

Carson Dyle:

--- Quote from: Roseweave on April 21, 2011, 07:18:51 AM ---There must be a more convenient solution?

--- End quote ---

Turn the player off while it's still connected to USB, disconnect the USB, then power up and it will boot directly into Rockbox without the Sansa firmware doing its refresh of media. If you've just finished a file operation, make sure you wait a few (10-20) seconds before powering down, just to be safe.

TheAlmightyGuru:
The Clip+ doesn't seem to want to turn off while it's connected to USB. How do you do it?

Carson Dyle:
The switch. It takes a while - maybe 20 seconds or so.

TheAlmightyGuru:
Ah, cool! Thank you sir!

Navigation

[0] Message Index

[#] Next page

[*] Previous page