Support and General Use > Hardware

Sansa Clip Plus Refreshing your media

<< < (3/3)

gyboth:

--- Quote from: Carson Dyle on April 22, 2011, 09:02:20 PM ---Turn the player off while it's still connected to USB, disconnect the USB, then power up and it will boot directly into Rockbox without the Sansa firmware doing its refresh of media. If you've just finished a file operation, make sure you wait a few (10-20) seconds before powering down, just to be safe.

--- End quote ---
This works for the refreshing after charging. However, my device also refreshes right after I plug it in (Win7), and it takes tons of time with the 32GB card until it's done and I can finally access the memory.

Any ideas?

Navigation

[0] Message Index

[*] Previous page