Rockbox General > Rockbox General Discussion

nano 2g display corrupted

(1/2) > >>

Adub:
I hope this is the right place to post this as i have been up and down the forums looking for a better place to no avail.

I have a nano 2g rockboxed using the latest RockboxUtility i installed rockbox again after not using the player for some time and when booting into rockbox i get this screen.



I have tried formating the device and reinstalling both the bootloader and the firmware multiple times with no success. I used to run rockbox with no problems and currently the OF works fine when i boot into it.

I can't seem to find this issue searching google and i am looking for guidance here as a last ditch effort before just giving the player away.

Thanks for any help.

Buschel:
There were quite some changes for the nano 2g LCD driver in december (r28794 - r28868). Which version worked for you? And with which version do you have the problems?

Edit: Can you also please check which lcd_type your nano 2g uses? This can be gathered from the debug hw info screen. You should either see "LCD: (7) LDS176" or "LCD: (2) ILI9320".

Edit2: Which WPS do you use? If it is not cabbie v2 can you please try again with this?

[Saint]:
To clarify, you'll need to roll back to a build that works in order to gain the information needed from the debug menu. We know it won't be possible to gather it with the screen in this state. ;)

TheSeven:
You can also gather this information from diagmode (hold left+select while powering on), in the "Others" => "Status" menu on the second page. (LCD_DETECT0 and LCD_DETECT1)

Adub:
Ok i rolled back to what i was using before which was a build from March (lol) r25375-100328, so it boots fine now, also using cabbiev2.

From diagmode it shows:
LCD Detect0:1
LCD Detect1:0

Also in hardware debug:
LCD:
type: 1, (7) LDS176

Navigation

[0] Message Index

[#] Next page