Support and General Use > User Interface and Voice

Sansa Clip+ -Hold

(1/1)

jaurbik:
I am going to be installing Rockbox on my new clip+ this evening, and in prep for that I was reading(well, actually scanning though) the manuel.  I did not notice any mention of a "hold" feature while using rockbox, would I access it the same as in the original firmware (holding down the home button) or though some other method?


I am looking forward to the additional functionality I expect from rockbox. 
 

saratoga:
Search the manual for "lock" IIRC.

jaurbik:
ah, that would be why i can't find "hold"   ;)  thanks.

Llorean:
Just as a note, this doesn't seem to be a question about how to install or remove Rockbox. It's a good idea to read the "POSTING IN THIS FORUM" posts to help you make sure your posts get in front of the right eyes.

saratoga:

--- Quote from: jaurbik on December 14, 2010, 04:16:23 PM ---ah, that would be why i can't find "hold"   ;)  thanks.

--- End quote ---

I added a note about this to the manual to make it easier to search for.  It'll show up when the manuals rebuild.

Navigation

[0] Message Index