Installation / Removal > Sandisk - Installation/Removal

Not sure if Rockbox was properly installed

(1/2) > >>

wicked.ludicrous:
I thought I had installed Rockbox correctly on my new Clip+.
It was connected to my laptop and detected in the correct drive in Rockbox utility. I went through everything, custom installation and installing the bootloader without problems.
But it seems like Rockbox wasn't installed... Everything looks the same even though I installed a new theme. Is Rockbox loaded only when I press certain keys during the start up?
Sorry if this is a newb-ish question, but I'm just confused as to why it isn't working/loading

Thanks

Chronon:
Did you install the firmware as well as the bootloader?  Rockbox should load automatically when the unit gets booted.  Holding a certain key is only necessary to boot the original firmware.

wicked.ludicrous:
I'm pretty sure I installed the firmware. I remember browsing for the OF and the Rockbox Utility accepting the file.
Or did I miss a step?

Llorean:
That's part of the bootloader installation. After you install the bootloader (or before, you can technically do it in either order) you must also choose to install Rockbox itself.

wicked.ludicrous:

--- Quote from: Llorean on November 29, 2010, 08:35:32 AM ---That's part of the bootloader installation. After you install the bootloader (or before, you can technically do it in either order) you must also choose to install Rockbox itself.

--- End quote ---

So in the Utility, under the Quick Start I've done Complete Installation several times. And under the Installation tab, I've done Install the bootloader and Install Rockbox.
Yet, I don't see Rockbox showing up.

Anything I forgot to do?

------Edit------
I actually figured out what was wrong, so no more problems with getting Rockbox.
But the music I've put on my Clip+ shows up in files, but not in database...

Navigation

[0] Message Index

[#] Next page