Support and General Use > Hardware
Clip+ DC offset
Carson Dyle:
Found this thread after doing a number of searches.
I hear what must be the same thing on my Fuze v2 when pausing. It's not present, however, when Fade on Stop/Pause is disabled. It happens what seems like a second or two after the music stops. Could be right at the end of the fade out. Also happens at the start of resuming playback of a paused track.
Rockbox 3.7.1 and the IEMs being used are MEElectronics M11+, if that's relevant.
jdc:
Yip that's exactly what I get, a little squeak just at the end of fade out and again when it is unpaused. I have since started a flyspray on the topic http://www.rockbox.org/tracker/task/11812 and discussed it on Head-Fi http://www.head-fi.org/forum/thread/528329/clip-dc-offset
Carson Dyle:
I'm surprised that the developers don't hear this since it happens with the default setting of fade enabled.
Could it be the results of some new hardware rev on the Clip+ and Fuze?
Llorean:
Some pops and other noises also only show up clearly in certain headphones, while being lost in others.
saratoga:
I just tried it with 16 ohm IEMs and with the same IEMs and an 80 ohm impedance adapter. Theres a very noticeable glitch without the impedance adapter, but nothing with it.
I'm pretty sure this didn't use to happen.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version