Rockbox Development > New Ports
Sansa Fuze+
Roboturner913:
I am using a 200 gb Sandisk Ultra Plus card in my Fuze+ with no issues.
In fact the only issue I have with the Fuze+ inherent to Rockbox is the slight screen flicker (not complaining, it's barely noticeable). It's a brilliant device otherwise.
If some enterprising soul were to ever hack one of these things up and implant the original Fuze scroll wheel in place of the touch controls - ah but that's a fantasy.
Pingouin:
Agreed, thanks to pamaury for making an otherwise hopeless device (good grief, this touchpad is really poorly implemented in OFW!) into something very usable that I've been using almost daily for several years. I only ever use the stock firmware to charge the battery (I'm not actually sure that the stock firmware is "better" at this task, but I also have Rockbox set to auto-resume, so if I was booting in Rockbox to charge the battery I'd have to remember to pause it when starting charging and play again before switching it off post-charging).
TBH, I only bought it once I knew that Rockbox was in the works for it :D I actually got another one in the meantime, but it died only a couple of years after purchase.
Wdtfs3:
I was attempting to use mkimxboot.exe to upgrade me sansa. but it will not work.
here is the output:
[INFO] mkimxboot models:
[INFO] Fuze+: idx=0 rb_model=fuz+ rb_num=72
[INFO] mkimxboot mapping:
[INFO] md5sum=c3e27620a877dc6b200b97dcb3e0ecc7 -> idx=0
[ERR] Cannot open input file
Result: -2
saratoga:
The input file you're trying to patch couldn't be opened. Assuming you gave it a valid firmware file, copy the whole log to pastebin and then link that here (the forums will cut it off you try to paste into a post).
Wdtfs3:
--- Quote from: saratoga on January 16, 2019, 07:48:36 PM ---The input file you're trying to patch couldn't be opened. Assuming you gave it a valid firmware file, copy the whole log to pastebin and then link that here (the forums will cut it off you try to paste into a post).
--- End quote ---
C:\Users\allen>Desktop\rbinstall\mkimxboot.exe -i firmware.sb -b bootloader-fuzeplus.sansa -o patched.sb -t dualboot
[INFO] mkimxboot models:
[INFO] Fuze+: idx=0 rb_model=fuz+ rb_num=72
[INFO] mkimxboot mapping:
[INFO] md5sum=c3e27620a877dc6b200b97dcb3e0ecc7 -> idx=0
[ERR] Cannot open input file
Result: -2
this is the entire output/input
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version