Rockbox Development > New Ports
Sansa Fuze+
pamaury:
So the red rectangle fits in the screen but the cursor goes out of the rectangle ?
Normally that's impossible :-/ Can you copy the values displayed on the screen (and in particular x_max and y_max) ?
metaphys:
RMI: id=1533 p=B7 s=E
xmax=3009 ymax=1974 res=82
I retested it precisly:
I unable to exced about 1700 (record 1696) on the vertical axe (by wich value I'm already at the end of the touchpad).
between 50-70 the point disapear from screen (througt not reaching the red line) but I see it's still tracked down because of the vertical value that are still droping to nearly zero
By the way by the time I wrote I've tested again and now this does not happen anymore (for the bottom part) but unstead, I reached the end of touchpad (no more tracking of value) between value 80-100.
I'm the one who take his device appart, so pehraps I just broked it partly? I does feel any problem when using it anyway...
EDIT:
Altogether I would say the cursor covert pretty well the whole surface except for the upper part of the red rectangle
pamaury:
I don't reach the extreme values either but normally the cursor CAN'T escape the rectangle by design (the value reported are always below the maximum) so I found it a bit strange :)
metaphys:
no no it does not! But being all the way down and disapearing leave the impression it's gone out of the screen... Plus the fact value are still tracked down (but I can't reproduce this right now...)
pamaury:
Hello,
just a quick post to say that I'm still alive but as I said previously, I don't have much time right now. I've tried to make the storage work (it's SD based) but without success for now...Perhaps I'll make some progress at the devcon next week-end :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version