Rockbox Development > New Ports
Sansa Fuze+
pamaury:
@blackshard: don't suffer from this issue at all, which format are you playing and what is the bitrate ? Can you upload a file on which it happen ?
Hi all,
I have tagged the V2 bootloader version and uploaded it so that Rockbox Utility can install it. I will thus removed the firmware my dropbox for obvious legal reasons. Please use the Rockbox Utility to update the bootloader as of now.
azhag:
Hi,
I tried to update the bootloader using the RU 1.3.1:
- checked the "Bootloader" to be installed,
- downloaded needed OF,
- RU did all the magic with patching and stuff,
- I rebooted to OF.
And I still have v1 of the bootloader.
Do I need to perform some additional steps to update it? Or do I have to wait some time until RU knows about v2?
pamaury:
Did the OF display the "upgrading" message ? Sometimes the OF doesn't trigger the update from mysterious reasons and you have to manually remove the firmware.sb file at the root of the device and start over again.
azhag:
--- Quote from: pamaury on November 15, 2013, 07:54:44 AM ---Did the OF display the "upgrading" message ?
--- End quote ---
No.
OK, I'll try again.
Edit: still no luck.
Edit 2: scratch that. After like third boot to OF (with the same firmware.sb!) it started to update itself. No idea why it didn't work at first.
Julian67:
The Rockbox Utility bootloader update worked first time for me. After unexpected bootloader install failure with previous version I found it works reliably if you connect the Fuze to PC in OF USB mode: with player powered off, hold down the hardware volume down button and connect USB cable. Fuze+ then connects in Sansa's USB mode and it recognises any new firmware.sb file and upgrades as expected on safe remove/umount and disconnection.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version