Rockbox Development > New Ports
Sansa Fuze+
metaphys:
so as some of you already notice, we have now a touchpad sentivity settings that pamaury and I implemented. (general setting > system)
I also improved the keymaps on FM.
Also some correction about on some keymaps hint that were wrong
fsclavo:
Thanks devs for this great work!
Pamaury: I downloaded firmware.sb and tried to upgrade bootloader on my fuze+, but OF is "ignoring" the upgrade. I tried several times, booting to OF, resetting the device, but OF always boot in normal mode, just like if firmware.sb doens't exists in root folder.
Do you have any ideas?
pamaury:
Try to download the file again, make sure it is named correctly with no space, cleanly umount the disk before unplugging.
monoid:
Many thanks to developers. New bootloader seems to work well, no problems so far. Charging started to work.
Also thanks for adding recording recently. And also it seems to me that touchpad reacts now in more predictable way. Even before it was by great deal better than original by Sansa, but now it seems to be fully satisfactory.
Thanks a lot!!! :)
megal0maniac:
--- Quote from: fsclavo on July 16, 2013, 11:53:27 AM ---Thanks devs for this great work!
Pamaury: I downloaded firmware.sb and tried to upgrade bootloader on my fuze+, but OF is "ignoring" the upgrade. I tried several times, booting to OF, resetting the device, but OF always boot in normal mode, just like if firmware.sb doens't exists in root folder.
Do you have any ideas?
--- End quote ---
I've also had this issue. I needed to copy the firmware.sb file onto the device while in the OF USB mode. Rockbox USB or bootloader USB would result in it being ignored.
Delete the file, then with the device off, hold volume down and plug in the USB cable then copy the file.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version