Rockbox Development > New Ports
Sansa Fuze+
metaphys:
Is it the files on the same location as for the LCD's test or is it somewhere else...
Yeah I feel quite stupid on this one... ::)
pamaury:
No, I committed the code to the SVN so if it's not the case you need to get the rockbox code using SVN, build the fuze+ bootloader and then use some tools to download the code to the device:
http://www.rockbox.org/wiki/HowToCompile
http://www.rockbox.org/wiki/SansaFuzePlusPort
I'll try to provide a binary if it's too much work but I can't do it on a regular fashion.
metaphys:
Ok, wait I will try to find my way through those link - if I can't, I will tell... ;)
kerobaros:
Currently compiling the toolchain to test this out. Question: does installing your bootloader to the Fuze+ overwrite the Sandisk bootloader? Is there a way to boot the original firmware again afterwards?
pamaury:
When booting in recovery mode, nothing is written to disk, your device will boot normally afterwards. The recovery mode is not an "installation", it's really just a way to run some binary without installing anything.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version