Rockbox General > Rockbox General Discussion
Sansa Fuze V2 Startup Issues
rianon:
f you install without the boot, there is no load Rockbox. If a boot that says that is not the firmware.
[ERR] Original firmware unknown, please try an other version. Tested Fuzev2 versions are : 2.01.17, 2.02.26, 2.03.31, 2.03.33
saratoga:
--- Quote from: rianon on December 05, 2010, 04:06:42 PM ---[ERR] Original firmware unknown, please try an other version. Tested Fuzev2 versions are : 2.01.17, 2.02.26, 2.03.31, 2.03.33
--- End quote ---
That means you didn't provide it with a valid fuzev2 firmware. Go back to the sandisk site and download one.
rianon:
Find a theme to my problem, but found no solution ...
http://forums.rockbox.org/index.php?topic=25068.0
I tried to revert to the old firmware 31, did not help the system will not start.
Post Merge: December 05, 2010, 04:30:55 PMСпаÑибо, поÑле очередных манипулÑций Ñ ÑˆÐ°Ð¼Ð°Ð½Ñким бубном вÑе удалоÑÑŒ запуÑтить. Сработала ÑÐºÐ°Ñ‡Ð°Ð½Ð½Ð°Ñ Ñ€Ð¾Ð´Ð½Ð°Ñ Ð¿Ñ€Ð¾ÑˆÐ¸Ð²ÐºÐ°. :) :)
Post Merge: December 05, 2010, 04:31:24 PMThank you, after the next manipulation shamanistic tambourine all failed to start. Fired downloaded native firmware. :) :) :)
saratoga:
--- Quote from: rianon on December 05, 2010, 04:18:42 PM ---Find a theme to my problem, but found no solution ...
--- End quote ---
No thats not your problem because it was fixed ages ago.
Nichlas:
I have followed the bug report on this problem and it seems that i have a problem with a defective radio to.
It wont work in OF, and thus the cause of rockbox hanging seems to have been identified.
However before the bootloader changed to be able to work with the new rockbox the radio worked fine.
Might there be a problem with the new bootloader and some fm-chips? Or alternatively a lot of radiochips are failing.
Can someone suggest a way to investigate further?
Thanks for all the hard work
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version