Rockbox General > Rockbox General Discussion
Sansa Clip+ Usb Support Dissabled
daboijordan:
If i understood what i was reading a previous version of rockbox had usb support enabled, but it was unstable so it was disabled. Im looking for help in trying to get it enabled i dont need it to be stable i just need to be able to have it work for about 10secs. I have been stuck on this all day can someone help?
saratoga:
--- Quote from: daboijordan on October 05, 2010, 09:48:44 PM ---If i understood what i was reading a previous version of rockbox had usb support enabled,
--- End quote ---
No it was never enabled for the Clip+. Its unfinished.
--- Quote from: daboijordan on October 05, 2010, 09:48:44 PM ---but it was unstable so it was disabled. Im looking for help in trying to get it enabled i dont need it to be stable i just need to be able to have it work for about 10secs. I have been stuck on this all day can someone help?
--- End quote ---
Theres a lot of discussion on it over the last couple weeks in the IRC logs, but IIRC all you need to do is uncomment "#define USE_ROCKBOX_USB" in /firmware/export/config/sansaclipplus.h then compile your own build with it.
That said theres not much point in doing this unless you're handy with USB and want to work on it. The controller doesn't seem to be initialized properly, so it errors out during transfers.
sockbox:
someone compiled a version w/ usb support. i have it installed on my clip+ and i have not had any issues with it.
*link updated for 3.7 build w/ USB support*
http://www.mediafire.com/?4j390qyw359btfz
http://anythingbutipod.com/forum/showthread.php?p=506872#post506872
sockbox:
Is USB supported in v3.7?
BigPapi:
--- Quote from: sockbox on October 31, 2010, 04:04:13 AM ---Is USB supported in v3.7?
--- End quote ---
It doesn't appear to be, at this point anyways.
Navigation
[0] Message Index
[#] Next page
Go to full version