Support and General Use > Recording
Recording via optical-in
whatboutbob:
Precompiled build with optical recording patch:
http://s41.yousendit.com/d.aspx?id=0XCI8CJMJU58F0EGPLQZ01OCE4
Please be aware that you may need to reset settings and enable optical out to get 'digital' recording working.
There's a reason the patch hasn't been commited yet...its still buggy. Have a toothpick handy while testing because if you attempt to record while there's no signal (or if it loses signal mid-way thru) the recording will hang. You'll need to reset the unit.
Good luck, and report back your results.
dwonk:
This is what I found regarding the SPDIF being properly recognized/captured:
You need to be feeding it a signal from your AD when you choose the source (digital) and then go to the recording screen. If you don't, there will be no signal. Also as whataboutbob has pointed out, the optical out needs to be turned on.
I was able to grab 3 minutes but the file header was all messed up. there was a 29MB file but I couldn't open it.
Another thing, if the next improvements are to be made, the recording setting should be saved somehow. Also, if the optical out has to be turned on everytime, it will be an extra step to engage the recording. Maybe implement the optical out being on when the in is selected for the source.
dgodwin:
I used the precompiled build from whataboutbob. I was able to transfer a 1.5hr DAT tape to the iRiver with no apparent problems. Again, the only overall issue I encountered was needing to have the dat player going when I went into the recording screen.
hellokitty:
Great !
Were you able to listen to the generated file ?
What settings did you use (khz,...) ?
Is there a recording limit ?
Where can I get whataboutbob's precompiled build ?
MU4L:
Top o' the page ;), Kitty ...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version