Support and General Use > Hardware

Brightness of Clip + is very low

<< < (3/5) > >>

funman:

--- Quote from: MichaelScofield on July 14, 2010, 09:27:02 AM ---I already saw the "contrast" entry in the settings, but it just does nothing.
--- End quote ---

This is the problem then, contrast works as intended on my Clip+ (change the brightness).

The Clip+ has 2 different LCD controllers, perhaps the 2nd controller works differently for the contrast.

Do you have a build environment setup to test patches?

EDIT: there is indeed a difference, in spacing of contrast steps.

Try setting MAX_CONTRAST_SETTING to 250 in firmware/export/config/sansaclipplus.h (You will end with 220 possible settings for contrast, just check that the maximum value works correctly)

MichaelScofield:
I don't really have a clue where to find the config file you mentioned.
Should I find it when plugging the Clip to my PC ?

saratoga:

--- Quote from: MichaelScofield on July 14, 2010, 11:33:43 AM ---I don't really have a clue where to find the config file you mentioned.
Should I find it when plugging the Clip to my PC ?

--- End quote ---

No, its in the rockbox source code.  And the answer to "Do you have a build environment setup to test patches?" would apparently be "No".

MichaelScofield:
Okay didn't really know that, sorry

//edit : better ? :p

Chronon:
Please remember to use complete words on these forums.

Thank you.  :)

Navigation

[0] Message Index

[#] Next page

[*] Previous page