Iriver h140, Music stops, buzzing sound happens

[Hellish]

Hi I have a iriver h140, with bootloader 7 pre4, and the latest rockbox build.

What happens I go to listen to music, and the songs play fine, but after the third song, the song stops, and the sound of a buzzing noise is heard, it is very loud.

(If i turn off the player and back on, and the song resumes the buzzing sound is heard again)

I can skip the song then the buzzing sound disappears, any ideas?

I know its not the flash card, cos I have tested it with another, plus with the original hard drive and they have the same problem.

[JdGordon]

is it always the same song? sounds like the file is corrupt

[Hellish]

No its not always the same song, it happens with every song, the files are not corrupt.

[Jay Solaries]

If you change back to HDD and then switch to OF, does this happen again?

[Hellish]

I need a modified original iriver firmware, as i wrote the rockbox firmware to ram.

Where could I get the modified file, its not hosted on rockbox because they say its illegal to have.

[Jay Solaries]

Seems you don't have the bin backup for the previous one.

You can find restore method under this link:http://www.rockbox.org/wiki/IriverFlashing
But I did not try this before. Per the statements, you need have the OF HEX file and change the ext name from .hex to .bin and use iriver_flash to restore the critical section to OF.

I can tell so far by now, good luck bro.

[Hellish]

I tried what you said Jay Solaries, renaming the .hex file to .bin, and when i try to flash it, i get a message saying, "Not an original firmware file".

[Jay Solaries]

Hellish, you should decode the OF at the first place that i almost forgot telling you. Then flash it to your iriver ram.