Installation / Removal > Rockbox Utility

help me packard bell vibe 500

(1/3) > >>

titomorti:
sorry for my English I'm Spanish, I have decided to install rockbox on my little used packard bell vibe 500 and I have done everything right but now it does not start and sends me a message saying to check the hdd and off, any solution please , how to turn back to its previous firmware or do I use rockbox that is stable?

Chronon:
It seems like this unit might have a bootloader USB mode.  What happens if you do these things:
1.    Turn off the player (Original Firmware).
2.    Connect your Vibe 500 to the computer using the data cable.
3.    Push and hold Power (for about 2 seconds) until the “USB” screen appears.

Hopefully, this will get your device connected in MSC mode.

Piki:
If you can get it in MSC mode as suggested above, you should be able to install Rockboy stable or go back to the old firmware following the Packard Bell instructions.

titomorti:
thank you for your quick response, but I have a problem with downloads of utilities that I need to leave the factory straight out of mp3, I mean the original firmware, and especially an application that asks me to update the firmware in the instruction manual comes to me as I should and I put a link packard bell that no longer exists, not if you can help me get everything I need for making the point mp3

AlexP:
I'm sorry but I don't understand.  Could you try rephrasing?

Navigation

[0] Message Index

[#] Next page