Support and General Use > Recording
Recording Enhancements Pack
petur:
the scale of the peak meters is configurable (both max and min)
wolfattack:
Peutur, I was not saying for logarithmic scale, i am saying linear scale. On Logrithmic you can chose the max and min. but on linear it is just percentage. On my previous build without the REP, i had been told that under the linear scale, the 50% mark corresponds to -12db, i am trying to figure out if it should be the same for the peak meter with this build and the REP.
petur:
just checked, and when using linear scale, you can still set min/max, of course those settings are also linear...
BayTaper:
--- Quote from: petur on April 01, 2007, 03:48:12 PM ---Well I just checked the code and balance is explicitly not done in AGC_SAFETY mode...(apps/recorder/recording.c line 299)
So I tried myself and there's no way I can make AGC_SAFETY change the balance: clipping on one channel while the other is silent and gain goes down on both.
BayTaper: sure you were using AGC_SAFETY?
--- End quote ---
I'm 100% sure cause it happens to me all the time, but I'm also using an older REP build -- I tend not to upgrade ever as long as things are stable. Sounds like maybe I should upgrade now though, eh? Thanks for checking, sounds like my bad for not keeping up with releases?
Mmmm:
At last... New patch, new build :o... see post#1
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version