Support and General Use > Recording
Recording Enhancements Pack
petur:
I know this is the REP thread, but could you *please* test with the latest CVS build as well? Just to figure out if this is related to a patch included in the REP
thanks
lurker:
petur: good point.
I loaded CVS-060622 (todays bleeding edge), reset settings, set "Show Recording Screen on Startup" to "yes". After powerdown and restart, recording screen is enterred but no audio from headphones. I must press Stop and Play to enable audio from headphones.
<edited post>
Ok, I've configured the dev environment and have downloaded the latest CVS code, built it, and I have the problem. I will try and play with it this weekend since (I think) I understand what gets called when and it doesn't look like there's that much that could go wrong. Will report back if/when I have any new information.
Mmmm:
Some of you will be pleased to hear that I've finally fixed the bug in my build (not in the REP) with the joyclick patch (where when clicking, it did a double select in menus)...
I have also added Rincewind's patch for customising the record button (to the REP and my build).
And of course my build is up to date with current CVS now too (with a date stamp just for Dunno ;)).
See post#1 as usual for all updated stuff :)
EDIT: just a few afterthoughts... ;)
lurker:
ok, I tracked down my no audio if "Show Recording Screen on Startup" set to "yes" problem. Turns out that it appears the HW seems to need a kick that it's not getting before jumping to the recording screen. At least this is true for the current CVS version on two units I have access to. Anyway, the patch was trivial and is attached (it's a one-liner). I've submitted it for inclusion in CVS.
Mmmmm, any possibility of getting it included in your REP build?
If not, anyway for me to get a zip of your REP patches and I'll apply it to the current CVS, now that I can build ;D
[attachment deleted by admin, too old]
Mmmm:
--- Quote from: lurker on June 23, 2006, 01:57:17 PM ---ok, I tracked down my no audio if "Show Recording Screen on Startup" set to "yes" problem. Turns out that it appears the HW seems to need a kick that it's not getting before jumping to the recording screen. At least this is true for the current CVS version on two units I have access to. Anyway, the patch was trivial and is attached (it's a one-liner). I've submitted it for inclusion in CVS.
--- End quote ---
ooh, well done...It's a bit weird that you have this problem on two units and (if everyone's silence is anything to go by) nobody else has this problem at all isn't it? ???.
--- Quote ---Mmmmm, any possibility of getting it included in your REP build?
If not, anyway for me to get a zip of your REP patches and I'll apply it to the current CVS, now that I can build ;D
--- End quote ---
You can find the REP patch in post#1 of this thread... :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version