Sansa Fuze V2 OF 02.03.33F Rockbox installed, but won't run

[rbvivo]

Using rbutil to install bootloader and firmware, eveything went through nicely, but after restarting, i still have the OF on screen.

I can see the rockbox related files on the fuze.

Did i miss a point?


thx,

rbvivo

[saratoga]

Some FuzeV2 players will refuse patched files.  I don't think anyone knows why.  Theres a note about it here:

http://www.rockbox.org/wiki/SansaAMS#Specific_problems

If thats the case you'll have to wait until someone figures out whats going on.

[rbvivo]

 

Can i provide help in any way?

[funman]

Yes, perhaps a good idea would be to open a bug in flyspray to gather information.

Some people had started collecting serial numbers in the sansa thread of New Ports section.

You could check the last pages (I think all the info about this problem is in the last 10 pages or less), and extract the information about this problem, then put it on flyspray so others can contribute

[rbvivo]

done :-)


http://www.rockbox.org/tracker/task/11406





mc2739 edit: added link to flyspray task

[Piki]

I didn't know that rbutil worked with the v2? I couldn't find the v2 in rbutil (even with the disabled ports box checked), so ended up doing a manual installation.

[funman]

I didn't know that rbutil worked with the v2? I couldn't find the v2 in rbutil (even with the disabled ports box checked), so ended up doing a manual installation.

rbutil 1.2.7 works fine
The issue mentioned in this thread is fixed in r27441 so mkamsboot built from SVN will work.

However Sandisk added this "feature" of not upgrading below 2.3.31 because of a hardware change, and we need to handle this change in rockbox too.

Currently the fuzev2 I have doesn't boot and just show "ATA error: -2", I guess a bit more work is needed before those new fuzev2 work fine in rockbox.