Installation / Removal > Sandisk - Installation/Removal
fuze v2 manual installation
scrob:
This sounds as if I'm going to brick my sansa.. Ok, I guess I'll just have to wait.
djphatic:
I have just got my v2 fuze, plugged in the usb and first thing I did was update the firmware and then try to install Rockbox. I have followed the instructions on the website and in the manual to do a manual install but whenever I unplug the USB all I get is "Refreshing your media".
The same thing happens even if I used a unpatched firmware, as I tried to downgrade to get rid of the EU volume limit in the latest version (I know I can get rid of this via factory reset and selecting rest of the world).
Has anyone got any suggestions how to force the firmware update?
saratoga:
Are you sure you have the firmware file named correctly for your specific player? Trying to use either a misnamed firmware file, or a firmware for a different player then you own will cause that.
djphatic:
I have renamed the patched.bin to fuzpa.bin, which is the original filename from the original firmware.
In the system settings > info I have version as v02.03.33P
saratoga:
--- Quote from: djphatic on May 25, 2010, 04:12:33 PM ---I have renamed the patched.bin to fuzpa.bin, which is the original filename from the original firmware.
In the system settings > info I have version as v02.03.33P
--- End quote ---
That sounds fine. And you're putting it in the root of your player (e.g. "E:\fuzpa.bin") and not somewhere else?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version