Support and General Use > Hardware

Fuze V1 - Undefined instruction at 0x00000474

(1/3) > >>

Eibwen:
I tried installing with the 3.5 installer on a Fuze V1 2GB
I believe it would show the RockBox logo screen, then almost immediately show:

Undefined instruction at 0x00000474

It definitely did not show any UI.

I tried installing with both Firmware 01.02.26 and 01.02.31

Holding the arrow button to boot normal firmware worked, and flashing with original firmware restored it to working order

I did all of it on Windows 7 64bit.

saratoga:
Could you try downloading the latest build (from the download link on the left side of the screen) and unzipping it to your player?

Eibwen:
I remembered slightly incorrectly, the error is "Undefined instruction at 00000474" (no 0x)

And it flashes the boot screen for less than a second, it is apparently "Boot Ver 1.0RC" then goes to that error message

Extracting .rockbox from build r24992 did nothing at all.


Using the manual bootloader install process (the versions linked to by this page http://www.rockbox.org/wiki/SansaAMS#Installation_for_Stable_e200v2_F):
Original firmware 01.02.31 gave an error message (the install program did not give any errors and seemed to patch it)
01.02.26 it says patched succeeded

But putting that firmware on still resulted in the same error

funman:
Try removing the .rockbox directory:

If the error is still there the problem is in the bootloader

If instead you see something like "no .rockbox directory" then the error is in the build, and you can try using a current build to see if it fixes the problem.

Eibwen:
The error is still there when there is no .rockbox directory, so the boot loader is not working on mine

Navigation

[0] Message Index

[#] Next page