Support and General Use > Audio Playback, Database and Playlists

cross fade mix mode issue on iriver h120

<< < (3/3)

littlenick:
Thank you karashata for this explicit answer.

Well - I did try, first enable time-stretch, turn off my iriver, turn it back on to reboot, selected a song to play and then went to pitch screen.

All I succed in doing is slowing down or speeding up the song  - but pitch changes accordingly!

Went back to sound settings and time stretch to check if it is still enabled. Yes it still is.

Back to the pitch screen. Move the navi button up and down - all I get is playback speed alteration with pitch distortion.

I cannot make much use of the right/left function of the navi button - this gives me only a temporary small pitch change (indicated is 2%) of the current value.

But I don't get to any other screen.

So what do you mean with "You'll have to change screen a couple of times before you can adjust speed without affecting the pitch.
The pitch screen seems like a dead end to me - just like the timestretch function never had been implemented???

Sorry for asking so stupid questions

Tom

karashata:
I'm not sure what button you need to press on the H120 to change the mode (probably should have referred to it as mode the first time), but when timestretch is enabled there should be four different modes the pitch screen can use, those being pitch, semitone, pitch (with timestretch) and semitone (with timestretch). You'll need to figure out which button to press to change the mode to one of the last two in order to be able to adjust pitch and speed separately.

littlenick:
Oh - it's the A-B button!
How embarrassing - I should have paid attention to the key function table in the manual.

Now it's working. Fascinating feature! What a pity it isn't worked into a "DJ-mode" mix program.

Thanks to everyone who helped me along!

Greetings, Tom

yapper:
 ;) the manual IS useful

Navigation

[0] Message Index

[*] Previous page