Rockbox General > Rockbox General Discussion

e260 v1 or v2

<< < (2/2)

yapper:
With no USB on a v1 I see for GPIO B EF and it changes to FF when the USB cable is connected.

Can you list the boot version you have installed, and the version of Rockbox you have installed?
Both are displayed when the unit is powered on.

mc2739:

--- Quote from: rwspark on October 18, 2009, 08:09:31 PM ---I turned it on with NO USB and held select  - B: FF
Then I plugged in the USB and have the same - B: FF

--- End quote ---

On my e200v1, with no cable connected, I get B: EF
And when I connect the cable, I get B: FF

This confirms that you have a stuck bit that Rockbox uses to detect USB mode. This is a hardware issue.

With some modifications to Rockbox, you may be able to get it to boot to the main menu with no keypress, go to charge mode with the select (like current operation), and enter USB mode with another (maybe REC).


--- Quote from: rwspark on October 18, 2009, 10:42:21 AM ---Thanks. It still auto selects V2 even after installing Rockbox software for V1.

--- End quote ---

In Rockbox Utility, on the main screen, click the change button.  On the Configuration screen, press the Autodetect button on the bottom.  With my e200v1, it autodetects correctly.  Click OK to save the selected device.  After you exit the program, it will retain your selected device.

rwspark:
Thanks for your help. I was thinking it could be a hardware issue since it is a refurb, just strange it works with original firmware but not rockbox.

Navigation

[0] Message Index

[*] Previous page